I currently own and drive a 1987 Toyota Supra Turbo I chose to go with this car because I feel that it has a lot more potential than the MK4 generation Toyota Supra's also it is a challenge to build this car up to have the same potential as the MK4 Supra's but that is what I am out to do is build a one of a kind MK3 supra.

The current modifications on the car is it has a 3" Defcon downpipe that goes into a 3" exhaust system with a 3" test pipe in place of the cat then the rest runs into a 3" random technologies exhaust system with makes a nice low tone not a high pitch sound that gets annoying after 5 minutes.

My supra also has a Stage 2 ACT racing clutch with a fidanza Billet aluminum racing flywheel. There is a DNA manual boost controller thats currently running 13 psi. I still have the stock CT-26 turbo in the car. I had the head and block resurfaced and i put in a HKS 1.2mm bead type head gasket. The engine has been rebuilt to stock toyota specs with about 36xxx on the motor. Also a full metal frount mount intercooler with 2.5 aluminum piping with a greddy RS blow off valve.

For suspension i only currently have a front and rear sway bar installed.

Inside the car I have hooked up an APEXI S-AFC to tune the Air/Fuel ratio. I also put in a pillar pod with a boost gauge, water temp gauge, air/fuel gauge, and oil pressure gauge.

My plans for the car are to have it as a Daily Driver but set it up to be a beast at SCCA and the 1/4 mile strips. Also to be a really responsive vehicle with the right suspension setup.

Im looking for just about any sponsorship that will help me with getting parts for my car that can work with me in some way.















Also here is a video I took so you can have an idea of what the car sounds like.

http://s56.photobucket.com/albums/g180/x...0_0624.flv

Very nice - they are quick as well!!!